Chris Craft Concept 197

Chris Craft Concept 197. This boat was built in 1997 and very well made as i understand no wood was used so nothing to rot. Featuring boats suited for waterskiing, wakeboarding or simply cruising waters, the use of stainless.

Chris Craft Concept 197
Big Air Cuda wakeboard tower on a 1994 Chris Craft 197 from www.pinterest.com

This inboard/outboard runabout is 18.83 feet long and weighs 2650 (pounds dry). I'm just looking for other concept owners to share their experiences with this boat. Seller 99.9% positive seller 99.9% positive seller 99.9% positive.

Read More

Chris Craft Concept Bowrider 197 Brochure.

Compare products | order status | contact us; Despite the fiberglass hull on this runabout, we recommend that the boat be kept. Fully trailerable, custom covers offer the best protection for your boat.

Quality Boat Covers For Your Chris Craft 197 Concept Boat.

Get boat covers at the lowest prices at wholesale marine! Posted over 6 years ago in livermore, ca. The beam of this craft is 93 inches.

This Boat Has An Pmc Cobra 5.0L Multiport Engine With Fresh Water Heat Exchanger.

This weight does not account for passengers, fuel, or gear. Got it all put back together, and found it needed starter also (seized). $161.74 + $18.00 shipping + $18.00 shipping + $18.00 shipping.

The Boat Weighs Approximately 2300 Pounds With An Empty Fuel Tank And Without Any Gear Or Passengers.

Trailer has new leaf springs. Now it cranks over fine, and will run on starting fluid sprayed into intake but only for. We offer taylor boat covers at lowest prices with superior service.

Luxury Craft $ 24.75 Chris Craft 167 Concept Brochure Chris Craft $ 28.75 Chris Craft 1930 Ruanbout Model 103 Reproduction Brochure Chris Craft $ 48.75 Sold Out

I just bought a 1996 21' chris craft concept. This inboard/outboard runabout is 18.83 feet long and weighs 2650 (pounds dry). Tan , mercruiser certified technician replied 10 years ago water comes in through the pick ups in the drive and goes through the engine and out through the exhaust manifolds, risers and then over board out.

Leave a Reply

Your email address will not be published. Required fields are marked *